Difference between revisions of "3D Printing"

Revision as of 17:37, 22 September 2018

HSGR 3D printers are controlled via octopi.

1. TAZ 4: http://octopi.hsgr.awmn/
2. AO100: http://octopi.hsgr.awmn/A100/
3. Delta: WiP
4. CnC: WiP

Username: hsgr Password: hsgr3d

Some ground rules

1. Important: Make sure that the printer bed is free from objects before printing.
2. Keep uploaded files tidy by using folders.
3. Do not stop prints of other users.
4. Replace printer bed tape when it is damaged.

Printing

1. Generate GCode using Slic3r or Cura and the appropriate printer profile.
   1. In order to generate GCode for TAZ4, it is necessary to use these configuration files due to update with E3D Hot-end [1], [2]. The default extrusion nozzle: 0.4mm. Also the firmware was updated to Marlin 1.1.8.
   2. In order to generate GCode for anadelta, it is necessary to use these configuration files. The default extrusion nozzle: 0.4mm. Also the firmware was updated to Marlin 1.1.8.
   3. In order to generate GCode for AO100, it is necessary to use these configuration files.

1. Connect to octopi
2. Upload file
3. Turn on the printer
4. Apply the appropriate adhesive for the material you are printing with to the bed
5. Set temperatures if not set by GCode
6. Print !!!
7. Turn off the printer